Airworthiness Directive 2010-26-09
one-timeAirworthiness Directives; Sikorsky Aircraft Corporation (Sikorsky) Model S76A, B, and C Helicopters
What this AD requires
This amendment supersedes an existing emergency airworthiness directive (EAD) for the specified Sikorsky model helicopters. The EAD requires inspecting the LITEF Attitude Heading and Reference System (AHRS) unit of the navigation system to determine if it is at a Mod Status "18." If either AHRS unit is at Mod Status "18," the EAD requires installing placards on the instrument panel to prohibit single pilot instrument flight rule (IFR) and single pilot night flight and reducing airspeeds to 120 knots indicated airspeed (KIAS) if both autopilots uncouple during instrument meteorological conditions (IMC) or night flight. The EAD also requires inserting minimum crew and airspeed limitations into the Limitations section of the applicable Rotorcraft Flight Manual (RFM) to limit the minimum flight crew to 2 pilots for night flight and IFR flight and to reduce airspeed to 120 KIAS if both autopilots uncouple during IMC or night flight. This amendment contains the same requirements but draws the appropriate distinctions between IFR and IMC as used in the intended operating limitations. Also, unlike the EAD, this AD states the airspeed must be reduced to 120 KIAS if both autopilots uncouple during IMC or night flight. Further, we are removing the limitation contained in the Active Temporary Revisions relating to pilots keeping their hands and feet near the flight controls. This AD was prompted by the need to supersede the EAD to state the distinction between IFR and IMC as used in the operating limitations and to reduce the airspeed to 120 KIAS if both autopilots uncouple during IMC or night flight. The actions specified by this AD are intended to implement operating limitations based on an anomaly in the AHRS related to the 26 volt AC inverter that could result in a decoupling of both autopilots and to prevent loss of control of the helicopter during IMC and during night flight.
Which aircraft AD 2010-26-09 applies to
Applicability depends on the aircraft’s type certificate — check it against the specific tail.
Whether AD 2010-26-09 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.