Airworthiness Directive 2010-26-03
one-timeAirworthiness Directives; Hawker Beechcraft Corporation Models B200, B200GT, B300, and B300C Airplanes
What this AD requires
We are superseding an existing airworthiness directive (AD) for the products listed above. That AD currently requires fabricating and installing a placard incorporating information that limits operation when there is known or forecast icing and requires replacing a section of the pneumatic supply tube for the tail deice system with a new tube of a different material. This AD requires fabricating and installing a placard incorporating information that limits operation when there is known or forecast icing and requires replacing the entire length of the pneumatic supply tube for the tail deice system with a new tube of a different material. This AD was prompted by reports of two failures of the pneumatic supply tube for the tail deice system outside the area covered by AD 2008-07-10. We are issuing this AD to prevent collapsed pneumatic supply tubes, which could result in failure of the tail deice boots to operate. This failure could lead to loss of control in icing conditions.
Which aircraft AD 2010-26-03 applies to
Whether AD 2010-26-03 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.