Airworthiness Directive 2010-26-01
one-timeAirworthiness Directives; The Boeing Company Model 777-200 Series Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) for certain Model 777-200 series airplanes. This AD requires installing a new insulation blanket on the latch beam firewall of each thrust reverser (T/R) half. This AD results from an in-flight shutdown due to an engine fire indication; an under-cowl engine fire was extinguished after landing. The cause of the fire was uncontained failure of the starter in the engine core compartment; the fire progressed into the latch beam cavity and was fueled by oil from a damaged integrated drive generator oil line. We are issuing this AD to prevent a fire from entering the cowl or strut area, which could weaken T/R parts and result in reduced structural integrity of the T/R, possible separation of T/R parts during flight, and consequent damage to the airplane and injury to people or damage to property on the ground.
Which aircraft AD 2010-26-01 applies to
Applies to airplanes identified in Boeing Alert Service Bulletin 777-78A0066, Revision 2, dated April 8, 2010.
Whether AD 2010-26-01 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.