Is AD 2010-23-10 a recurring Airworthiness Directive?

Yes — AD 2010-23-10 requires a repetitive inspection. Next-due depends on the aircraft's time in service.

Airworthiness Directive 2010-23-10

Q: Which aircraft does AD 2010-23-10 apply to?

AD 2010-23-10 applies to Mcdonnell Douglas Corporation — models DC-9-14, DC-9-15, DC-9-15F, DC-9-21, DC-9-31, DC-9-32, DC-9-32 (VC-9C), DC-9-32F. Serial/part conditions may narrow it to specific aircraft.

recurring

Official AD 2010-23-10 · FR doc 2010-28084 · 2010-11-09 · airframe

Airworthiness Directives; McDonnell Douglas Corporation Model DC-9-14, DC-9-15, and DC-9-15F Airplanes; and Model DC-9-20, DC-9-30, DC-9-40, and DC-9-50 Series Airplanes

What this AD requires

We are superseding an existing airworthiness directive (AD) for the products listed above. That AD currently requires repetitive high frequency eddy current inspections to detect cracking in the vertical radius (also known as the "vertical leg") of the upper cap of the center wing rear spar, and repair if necessary. This new AD expands the area to be inspected by including inspections to detect cracking of the horizontal flange of the upper cap of the left and right center wing rear spar, and repair if necessary. This new AD also adds certain airplanes to the applicability. This AD was prompted by reports of cracking in the vertical radius of the upper cap of the center wing rear spar, and the horizontal flange on the inboard side of the of the rear spar upper cap, which resulted from stress corrosion. We are issuing this AD to detect and correct cracking in the vertical leg or the horizontal flange of the upper cap of the left or right center wing rear spar, which could cause a possible fuel leak, damage to the wing skin, and structural failure of the upper cap, and result in reduced structural integrity of the airplane.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 2010-23-10 applies to

MakesMcdonnell Douglas Corporation

ModelsDC-9-14, DC-9-15, DC-9-15F, DC-9-21, DC-9-31, DC-9-32, DC-9-32 (VC-9C), DC-9-32F, DC-9-33F, DC-9-34, DC-9-34F, DC-9-32F (C-9A, C-9B), DC-9-41, DC-9-51, DC-9

Applies to airplanes identified in Boeing Service Bulletin DC9-57-223, Revision 1, dated August 13, 2009.

Whether AD 2010-23-10 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.

Date — When the work was done.

Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.

Signature & certificate — The A&P/IA who returned it to service, with certificate number.

Is AD 2010-23-10 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.