Airworthiness Directive 06-5529
one-timeAirworthiness Directives; Pacific Aerospace Corporation Ltd. 750XL Airplanes
What this AD requires
We are adopting a new airworthiness directive (AD) that supersedes AD 2005-26-53, which applies to certain Pacific Aerospace Corporation Ltd. (PAC) 750XL airplanes. AD 2005-26-53 currently requires you to insert text into the Limitations Section of the Airplane Flight Manual (AFM) that reduces the maximum takeoff weight from 7,500 pounds to 7,125 pounds. This AD results from mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for New Zealand and the FAA's decision that the actions correct an unsafe condition. Consequently, this AD would require you to remove rivets that have not been fully age hardened and replace them with bolts, washers, and nuts in specific locations where reduction in rivet strength affects overall structural capability. This AD retains the actions of the previous AD until the rivets are replaced with the bolts, washers, and nuts. We are issuing this AD so that wing ultimate load requirements are met. If wing ultimate load requirements are not met, wing failure could result with consequent loss of control of the airplane.
Which aircraft AD 06-5529 applies to
certain
Whether AD 06-5529 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.