TailplateTailplate
Run a report

Airworthiness Directive 05-9976

recurring
AD 05-9976 · 2005-05-23 · airframe

Airworthiness Directives; AeroSpace Technologies of Australia Pty Ltd. Models N22B, N22S, and N24A Airplanes

What this AD requires

The FAA adopts a new airworthiness directive (AD) to supersede AD 2003-14-20, which applies to all AeroSpace Technologies of Australia Pty Ltd. (ASTA) Models N22B and N24A airplanes. AD 2003-14-20 requires you to repetitively inspect, using either dye penetrant or magnetic particle methods, the rudder control lever shafts for cracks; inspect (one-time) all lever shaft side plates by measuring the thickness; and if cracks or discrepancies in thickness are found, replace unserviceable parts with new or serviceable parts. Since AD 2003-14-20 was issued, we determined that the AD should also affect Model N22S airplanes. The manufacturer has also revised the service information to include a rudder control lever shaft part number (P/N) that was not part of AD 2003-14-20. Consequently, this AD retains the actions of AD 2003-14-20, adds Model N22S airplanes to the applicability, and adds rudder control lever shaft P/N 1/N-45-1102 to the inspection requirements. We are issuing this AD to detect and correct cracks in the rudder control lever torque shafts and discrepancies in the thickness of the lever shaft side plates, which could result in failure of the rudder control lever torque shaft. Such failure could lead to reduced controllability of the airplane.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 05-9976 applies to

MakesAerospace Technologies Of Australia Pty Ltd
ModelsN22B, N22S, N24A

applicability derived from the AD summary — confirm the model/serial from the records

Whether AD 05-9976 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 05-9976 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.