Is AD 05-12841 a recurring Airworthiness Directive?

Yes — AD 05-12841 requires a repetitive inspection. Next-due depends on the aircraft's time in service.

Which aircraft does AD 05-12841 apply to?

AD 05-12841 applies to Bombardier — models DHC-8-200, DHC-8-300. Serial/part conditions may narrow it to specific aircraft.

Airworthiness Directive 05-12841

recurring

AD 05-12841 · 2005-08-22 · airframe

Airworthiness Directives; Bombardier Model DHC-8-100, DHC-8-200, and DHC-8-300 Series Airplanes

What this AD requires

The FAA is superseding an existing airworthiness directive (AD), which applies to all Bombardier Model DHC-8-100, DHC-8-200, and DHC-8-300 series airplanes. That AD currently requires installation of a placard on the instrument panel of the cockpit to advise the flightcrew that positioning of the power levers below the flight idle stop during flight is prohibited. Additionally, the existing AD requires eventual installation of an FAA-approved system that would prevent such positioning of the power levers during flight. Installation of that system terminates the requirement for installation of a placard. This new AD requires operators who have incorporated a certain Bombardier service bulletin to perform repetitive operational checks of the beta lockout system and to revise the Airworthiness Limitations document. This AD is prompted by in-service issues reported by operators who incorporated Bombardier Service Bulletin 8-76-24 as an alternative method of compliance to the existing AD. We are issuing this AD to prevent the inadvertent activation of ground beta mode during flight, which could lead to engine overspeed, engine damage or failure, and consequent reduced controllability of the airplane.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 05-12841 applies to

MakesBombardier

ModelsDHC-8-200, DHC-8-300

certain

Whether AD 05-12841 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.

Date — When the work was done.

Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.

Signature & certificate — The A&P/IA who returned it to service, with certificate number.

Is AD 05-12841 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.