Airworthiness Directive 03-26723
recurringAirworthiness Directives; Cessna Model 750 Citation X Series Airplanes
What this AD requires
This amendment rescinds Airworthiness Directive (AD) 98-16-17 R1, which is applicable to all Cessna Model 750 Citation X series airplanes. That AD requires repetitive in-flight functional tests to verify proper operation of the secondary horizontal stabilizer pitch trim system, and repair if necessary. The requirements of that AD were intended to detect and correct contamination and damage in the system actuator, which could result in simultaneous failure of both primary and secondary pitch trim systems, and consequent reduced controllability of the airplane. Since the issuance of that AD, an improved part has been developed, which, if installed, would terminate the repetitive tests; that improved part has been installed on all affected airplanes or is being installed in production. Therefore, the identified unsafe condition no longer exists.
Which aircraft AD 03-26723 applies to
Whether AD 03-26723 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.