Airworthiness Directive 2003-21-07
one-timeAirworthiness Directives; The Cessna Aircraft Company Model 525 Airplanes
What this AD requires
The FAA is adopting a new airworthiness directive (AD) for certain The Cessna Aircraft Company (Cessna) Model 525 airplanes. This AD requires you to disengage the pitch trim circuit breaker and AP servo circuit breaker and then tie strap each of them to prevent them from being engaged. This AD is the result of analysis that reveals the potential for a single-wire shorting to 28 volts or a failure of a relay in the electric pitch trim system such that the relay contacts remain closed. We are issuing this AD to correct this single-point failure in the electric pitch trim system, which will result in a runaway pitch trim condition where the pilot could not disconnect using the control wheel autopilot/trim disconnect switch. Failure of the electric trim system would result in a large pitch mistrim and would cause excessive control forces that the pilot could not overcome.
Which aircraft AD 2003-21-07 applies to
Whether AD 2003-21-07 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.