Airworthiness Directive 01-30195

one-time
AD 01-30195 · 2001-12-12 · airframe

Airworthiness Directives; McDonnell Douglas Model DC-9-10, -20, -30, -40, and -50 Series Airplanes; C-9 Airplanes; Model DC-9-81, -82, -83, and -87 Series Airplanes; and Model MD-88 Airplanes

What this AD requires

This amendment adopts a new airworthiness directive (AD), applicable to certain McDonnell Douglas Model DC-9-10, -20, -30, -40, and -50 series airplanes; C-9 airplanes; Model DC-9-81, -82, -83, and - 87 series airplanes; and Model MD-88 airplanes, that requires an inspection to detect chafing or overheat damage of the electrical wires located at fuselage station Y=110.000 bulkhead of the lower nose left tunnel; and corrective actions, if necessary. This AD also requires replacing the external power ground stud with a new ground stud using new attaching parts, torquing new attachments, and installing a nameplate. This action is necessary to prevent loose external power ground wires, which could cause arcing and overheated wire insulation and consequent smoke/fire in the cockpit. This action is intended to address the identified unsafe condition.

Which aircraft AD 01-30195 applies to

ModelsMD-88

certain

Whether AD 01-30195 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of complianceThe specific action taken (inspected, replaced, modified) and to what revision.
DateWhen the work was done.
Aircraft timeTotal time in service / tach at compliance — how recurring next-due is computed.
Signature & certificateThe A&P/IA who returned it to service, with certificate number.
Is AD 01-30195 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.