Airworthiness Directive 2001-20-03
one-timeAirworthiness Directives; Bell Helicopter Textron Canada Model 206L-4 Helicopters
What this AD requires
This amendment adopts a new airworthiness directive (AD) for Bell Helicopter Textron Canada (BHTC) Model 206L-4 helicopters that requires installing a high altitude tail rotor static stop yield indicator (indicator) to allow operators to detect excessive bending loads sustained by the tail rotor yoke. A preflight check of the indicator is also required. This amendment is prompted by a determination that a tail rotor yoke with a high altitude rotor system is susceptible to a static and dynamic overload. Static overload could occur after the tail rotor yoke sustains an excessive bending load due to a strike from a ground vehicle. Dynamic overload could occur as a result of a hard landing. The actions specified by this AD are intended to prevent failure of the tail rotor yoke in flight and subsequent loss of control of the helicopter.
Which aircraft AD 2001-20-03 applies to
Applies only when High Altitude Tail Rotor Kit P/N 206-704-722-101 (per BHT-206-SI-2054) is installed.
Whether AD 2001-20-03 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.