TailplateTailplate
Run a report

Airworthiness Directive 00-30397

recurring
AD 00-30397 · 2000-12-04 · airframe

Airworthiness Directives; Boeing Model 707 and 720 Series Airplanes

What this AD requires

This amendment adopts a new airworthiness directive (AD), applicable to all Boeing Model 707 and 720 series airplanes, that requires repetitive inspections of certain stringers and around certain fastener holes of the lower skin of the wings to detect fatigue cracking, and repair, if necessary. This action is necessary to detect and correct such cracking and consequent damage to adjacent structure, which could result in reduced structural integrity of the airplane. This action is intended to address the identified unsafe condition.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 00-30397 applies to

MakesBoeing
Models720

certain

Whether AD 00-30397 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of compliance — The specific action taken (inspected, replaced, modified) and to what revision.
Date — When the work was done.
Aircraft time — Total time in service / tach at compliance — how recurring next-due is computed.
Signature & certificate — The A&P/IA who returned it to service, with certificate number.
Is AD 00-30397 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.