Airworthiness Directive 00-28480
recurringAirworthiness Directives; McDonnell Douglas Model DC-9-10, -9-20, -9-30, -9-40, and -9-50 Series Airplanes and C-9 (Military) Airplanes
What this AD requires
This amendment adopts a new airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model DC-9-10, -9-20, -9-30, -9-40, and -9-50 series airplanes and C-9 (military) airplanes. This action requires, among other actions, measuring the diameter of the hole counterbore of the outboard idler hinge fitting of the left and right wing flap; performing repetitive high frequency eddy current inspections (HFEC) to detect cracks at the flap idler hinge fitting, if necessary; and replacing the flap idler hinge fitting with a new like part, if any crack is detected. This action is necessary to prevent failure of the outboard flap idler hinge fitting due to fatigue cracking, which could result in a deflected flap that may cause an asymmetric lift and consequent reduced controllability and structural integrity of the airplane. This action is intended to address the identified unsafe condition.
Which aircraft AD 00-28480 applies to
Whether AD 00-28480 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.