Airworthiness Directive 00-20775

recurring
AD 00-20775 · 2000-08-21 · airframe

Airworthiness Directives; Airbus Model A330 and A340 Series Airplanes

What this AD requires

This amendment adopts a new airworthiness directive (AD), applicable to certain Airbus Model A330 and A340 series airplanes, that requires repetitive inspections to check for backlash of the spherical bearing of the active aileron servo-controls, and follow-on corrective actions, if necessary. This amendment also provides optional terminating action for the repetitive inspections. This action is necessary to detect and correct excess backlash of the spherical bearing of the active aileron servo-controls, which could result in failure of the active aileron servo-controls and consequent reduced controllability of the airplane. This action is intended to address the identified unsafe condition.

Repetitive inspection. Re-inspect. The next-due date/hours depend on this aircraft’s time in service — a records report computes it from the logbooks.

Which aircraft AD 00-20775 applies to

MakesAirbus
ModelsA340

certain

Whether AD 00-20775 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.

How AD compliance is recorded

A valid compliance record (14 CFR 43.9) states:

Method of complianceThe specific action taken (inspected, replaced, modified) and to what revision.
DateWhen the work was done.
Aircraft timeTotal time in service / tach at compliance — how recurring next-due is computed.
Signature & certificateThe A&P/IA who returned it to service, with certificate number.
Is AD 00-20775 complied with on your aircraft?

Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.

Look up a tail number →Read the full directive (Federal Register)

Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.