Airworthiness Directive 00-13086
recurringAirworthiness Directives; Boeing Model 747-100, -200, -300, 747SR, and 747SP Series Airplanes
What this AD requires
This amendment supersedes an existing airworthiness directive (AD), applicable to certain Boeing Model 747-100, -200, -300, 747SR, and 747SP series airplanes, that currently requires a one-time inspection to detect cracking of the longeron splice fittings at stringer 11, on the left and right sides at body station 2598, and replacement of any cracked fitting with a new fitting. This amendment reduces the compliance time for accomplishment of the currently required inspection and adds a new requirement for repetitive inspections. This amendment is prompted by reports that fatigue cracking was found on longeron splice fittings. The actions specified by this AD are intended to detect and correct such fatigue cracking, which could result in reduced controllability of the horizontal stabilizer.
Which aircraft AD 00-13086 applies to
Whether AD 00-13086 actually applies to your aircraft (by serial and installed parts) and whether it’s already complied with comes from that aircraft’s records.
How AD compliance is recorded
A valid compliance record (14 CFR 43.9) states:
Tailplate reads a tail number’s logbooks and matches every applicable AD — including this one — to its compliance evidence, with recurring next-due dates computed.
Look up a tail number →Read the full directive (Federal Register)Applicability is derived from the FAA directive corpus and is advisory, not a legal airworthiness determination. Compliance is established only from an aircraft’s actual records.